76-86 CJ, 87-95 YJ, All TJ
Hanson Rocker Panels combine tough 3/16" steel, maximum
bottom and side impact protection, and sleek styling.
Panels attach easily with 5/16-18 truss head machine screws (provided) into
side of tub and up through floor pan on the bottom. Only
1/4" loss of ground clearance.
On TJ and CJ panels a
"Z" form is welded onto the bottom of the main panel
for bolting to the floor pan. Panels protrude out 2"
from tub and are 5 1/2" high on sides. The YJ panels
are one piece, and the form will slip into the rear of the front
flare once the caps are removed (see picture). Protrudes
out 3" from body and 5" high on the sides.
The ends of
all rockers are cut with a compound miter cut to match the flare
angle. They are capped and ground smooth. Capping
prevents the ends from distorting, as this is where the rockers
will take a good percentage of hits. Capping the ends is
an extra step that is worth the effort to create a much stronger
shipped bare steel. Powder coating available at an
All Panels - (All Years): 3/16" Hot Rolled Steel
All Panels - (All Years): $230.00