All CJ, YJ, TJ
Hanson can design and install custom roll cages for any
Jeep. Cages can consist of basic front additions to a
stock cage or a fully built external cage. For custom
work, arrangements must be made to leave vehicle with Hanson
Enterprise for several days or weeks.
For the TJ, a weld-in
cage kit has been developed. This kit retains the stock
cage, with the exception of the sport bars over the door
openings. The kit can be bought and installed in several
levels, or all at once. The kit MUST be welded in by an
experienced welder for optimal safety.
All tube ends are
fishmouthed to fit except where noted "trim to fit".
shipped bare steel. Powder coating available at an
--Replacement Sport Bars- 2 bars with door molding holes and
windshield flanges welded on. Main hoop flange supplied
(trim to fit).
--Three Bar Cage Kit- 2 front uprights, 2 base pads, 1 front
spreader to place between replacement Sport Bars.
--Front Mid Tubes- 2 center tubes extend from front spreader to
main hoop. Bent and notched in front, trim to fit in
--Dash Bar- Placed just above dash between front uprights to
help keep cage from buckling.
--Rear Spreader Hoop- Placed between stock rear tubes at apex of
curve to protect rear of Jeep.
--Rear Diagonals- 2 bars placed between the upper corner of the
main/rear hoop and the lower corner of the wheel wells/rear
--Handles- small handles welded into front upper corners in
front of cage.
TJ Kit: All tubes 1.75" x .120 HREW round tube (Handles
Replacement Sport Bars: $150.00
Three Bar Cage Kit: $270.00
Front Mid Tubes: $60.00
Dash Bar: $25.00
Rear Spreader Hoop: $50.00
Rear Diagonals: $80.00
Handles: $10.00 each
Cage Kit Available Options: