Click for Larger PictureAvailable for:
76-86 CJ, 87-95 YJ, All TJ

The Sierra front bumper gives a simpler look to the front end of the Jeep than the Rubicon series bumpers. It is 50" wide to provide some fender protection, but narrower than the Rubicon Series bumpers.  It has a flat top deck with winch mounting holes.  The lower front of the bumper is angled in 45 for better approach angle.  Tow hooks can be mounted atop the bumper using the stock mounting holes.

The Sierra series has a double-formed back edge.  This is to eliminate deflection of the bolting surface during a winching operation.  It also forms over the anti-sway bar on the TJ.

YJ and TJ bumpers mount with the four factory holes on top of the frame and the two factory holes below the frame.  CJ bumpers mount using the same frame holes as the stock bumper, with the addition of a side plate welded in the bumper.  This plate attaches to a bolt hole in the side of the frame for a considerably stronger mounting system.

Winches will sit flat on the bumper, and a fairlead mount will be necessary unless your fairlead mounts directly to your winch face.  The low stance of the winch allows maximum airflow into the grill.  All major brands of winch will mount to the provided holes.

D Rings should be used for straight pulls only, side pulls can cause ring failure.  Not to be used for towing.  Fairlead mount will accommodate warn, Ramsey, and Superwinch hawse and roller fairleads, as well as MileMarker rollers.  Shackle tabs hold a 3/4" shackle (not included).

All products shipped bare steel.  Powder coating available at an additional cost.

Available Options:
Fairlead Mount
D Rings
Shackle Tabs

Bumper: 3/16" Hot Rolled Steel
Shackle Tabs: 1" Hot Rolled Steel
Fairlead Mount: 1/4" Hot Rolled Steel
D Rings: 1/2" size, 4,000 lb. rating

CJ (76-86): $175.00
YJ & TJ: $160.00
Fairlead Mount : $50.00
Shackle Tabs w/ 7/8" Hole: $60.00
D Rings per Pair : $45.00

D RingFairlead MountShackle Tab (with shackle)